<b>Solid-liquid equilibrium measurements for the ternary system PCL + chloroform + nonsolvents (n-hexane, ethanol, methanol, isopropanol) at 303.15 K</b> - doi: 10.4025/actascitechnol.v36i1.16615
DOI:
https://doi.org/10.4025/actascitechnol.v36i1.16615Palavras-chave:
solid-liquid equilibrium, polycaprolactone, microencapsulationResumo
This work reports experimental data of polycaprolactone (PCL) polymer solubility in chloroform as solvent and n-hexane, methanol, ethanol and isopropanol as nonsolvents, at atmospheric pressure (about 1,0 bar) and temperature of 303.15 K. It was used PCL with 70000-90000 and 2000 molar mass (MM). The experiments of solubility were performed using a jacketed-cell with temperature controlled by an ultrathermostatic bath, in which a turbidity method was adopted and used. From the obtained results it should be observed that the n-hexane presented a more pronounced anti-solvent effect in the PCL solubility, where the heterogeneous region (solid phase presence) was broader than when other nonsolvent. It was also observed that the binodal curves measured with the high molar mass polymer showed similar results compared to the low molar mass one.
Â
Downloads
Downloads
Publicado
Como Citar
Edição
Seção
Licença
DECLARAÇíO DE ORIGINALIDADE E DIREITOS AUTORAIS
Declaro que o presente artigo é original, não tendo sido submetido í publicação em qualquer outro periódico nacional ou internacional, quer seja em parte ou em sua totalidade.
Os direitos autorais pertencem exclusivamente aos autores. Os direitos de licenciamento utilizados pelo periódico é a licença Creative Commons Attribution 4.0 (CC BY 4.0): são permitidos o compartilhamento (cópia e distribuição do material em qualqer meio ou formato) e adaptação (remix, transformação e criação de material a partir do conteúdo assim licenciado para quaisquer fins, inclusive comerciais.
Recomenda-se a leitura desse link para maiores informações sobre o tema: fornecimento de créditos e referências de forma correta, entre outros detalhes cruciais para uso adequado do material licenciado.











